Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Testing and Adjusting Section

Caterpillar — Testing and Adjusting Section

A Caterpillar service procedure — check it applies to your exact model before use.

Browse Caterpillar generators & specs →

Procedure

  1. Remove the speed sensor (1) from the flywheel
  2. By hand, screw the speed sensor (1) into the
  3. Turn the sensor (1) in the counterclockwise
  4. Tighten locknut (2) to 25 ± 5 N·m (18 ± 4 lb ft).

Source: manual:SOTA RENR7902-00-proof EMCP3.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.