Caterpillar — Starting the Unit
Operation · Engine
From a Caterpillar operator's manual — check it applies to your exact model before use.
Browse Caterpillar generators & specs →
Before you start
- Do not connect to building electrical system unless generator and transfer switch properly installed by qualified electrician
Procedure
- Add oil using funnel to recommended level
- Add fuel and rotate fuel valve to OPEN position
- Install lifting eye and torque bolts to 26 lb-ft (35 N-m)
- Connect battery (negative terminal)
- Assemble handle and install feet and wheels
- For cold engine: pull choke knob out; for warm engine: push choke knob in slowly
- Turn circuit breaker to ON position
- Rotate start switch to RUN
- Complete rotation to START
- Once running, adjust choke as needed
Tools required
- 13/15 mm wrench Amazon
- 14/17 mm wrench Amazon
- Spark plug wrench Amazon
- Screwdriver Amazon
- Oil funnel Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Lifting eye torque: 26 lb-ft (35 N-m)
Source: Caterpillar operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.