Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Repair: Turn off the genset. Replace the RFI filter.

Caterpillar — Repair: Turn off the genset. Replace the RFI filter.

A Caterpillar service procedure — check it applies to your exact model before use.

Browse Caterpillar generators & specs →

Procedure

  1. A. Stop the genset.
  2. B. Disconnect the KVAR/PF controller from the
  3. C. Connect a jumper to terminals 2 and 3.
  4. D. Start the genset and run the genset at no load.

Source: manual:CAT VR6 Service Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.