Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Repair: Temporarily replace the sensor. Verify that the repair eliminates the problem.

Caterpillar — Repair: Temporarily replace the sensor. Verify that the repair eliminates the problem.

A Caterpillar service procedure — check it applies to your exact model before use.

Browse Caterpillar generators & specs →

Procedure

  1. A. Disconnect ECM connector J1/P1, ECM connector J2/P2,and the suspect sensor connector.
  2. B. Use a suitable piece of wire to connect pin A to pin C.
  3. C. Measure the resistance between suspect sensor signal wire and the suspect sensor voltage supply
  4. D. Use a suitable piece of wire to connect pin B to pin C.
  5. E. Measure the resistance between the sensor signal wire and the sensor return line at the ECM
  6. F. Remove all wire shorts.
  7. G. Reconnect all connectors.

Source: manual:Engine Sensor Test 3500B.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.