Caterpillar — PEEC Throttle Switch Installation
Installation · PEEC position sensor / throttle switch
From a Caterpillar service manual — check it applies to your exact model before use.
Browse Caterpillar generators & specs →
Procedure
- Install the Pacbrake switch and bracket assembly in the location shown, using the existing mounting bolt.
- Select the appropriate threaded hole in the face of Caterpillar's position sensor and mount the actuating arm with the spacer and two shake-proof washers.
- With the sensor in the idle position, set the actuating arm so the switch is in the closed 'clicked' position and lock the 1/4-20 capscrew; torque to 125 lb.in (14.2 N.m).
- Operate the throttle to ensure the switch is actuated each time the throttle returns to idle and no interference exists.
Specs & values
- 125 lb.in (14.2 N.m)
Source: Caterpillar service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.