Caterpillar INV2000 — Engine Oil – Change

Maintenance

For the Caterpillar INV2000, from the Caterpillar owner's manual.

Applies to: Caterpillar INV2000

Procedure

1. Run engine to normal operating temperature, then stop.
2. Close vacuum relief valve to off.
3. Open right service door, remove and wipe oil level gauge.
4. Attach oil funnel, tilt generator to drain crankcase into container.
5. Refill oil and check level.
6. Install and tighten gauge, close service door.
7. Dispose of used oil properly.
8. Start engine briefly and check for leaks.
9. Stop engine and recheck oil level.

Source: Caterpillar owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Caterpillar repair guides →