Caterpillar SEHS7259-08 — Generator Alignment and Shim Installation Procedure

For the Caterpillar SEHS7259-08.

Applies to: Caterpillar Sehs7259 08

Procedure

1. Ensure generator is disengaged from engine
2. Remove all dirt, burrs and paint from contact surfaces of generator supports and base
3. Remove protective material from generator supports
4. Verify measurements against specified tolerances
5. If Item 14 is less than Item 1, repeat installation and check for calculation errors

Source: manual:Alignment of Single Bearing Generators.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.