Home›Repair guides›Caterpillar›Fuel Tank Water and Sediment - Drain

Caterpillar — Fuel Tank Water and Sediment - Drain

Maintenance

From a Caterpillar owner's manual covering: C3.3, C3.3 Rental Generator Set, C4.4, C4.4 Rental Generator Set, D4D1-Up, GLE1-Up, N3X1-UP, N4R1-Up, N4X1-Up, X3B1-UP, XYC1-Up, XYD1-Up. Check it applies to your exact model before use.

Applies to: Caterpillar C3.3, Caterpillar C4.4

Before you start

  • Water in the fuel can cause excessive wear to the fuel system
  • Dispose of all fluids according to local regulations and mandates

Procedure

  1. Open the drain valve on the bottom of the fuel tank.
  2. Drain the water and the sediment. Close the drain valve.
  3. Check the fuel daily. Drain after operating the engine or after the fuel tank has been filled.
  4. Allow five to ten minutes before performing this procedure.
  5. Fill the fuel tank after operating the engine in order to drive out moist air.
  6. Do not fill the tank to the top; fuel expands as it gets warm.

Full service-parts list: Caterpillar C3.3 →, Caterpillar C4.4 →

Source: Caterpillar owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Caterpillar repair guides →