Caterpillar — Procedure 4

A Caterpillar service procedure — check it applies to your exact model before use.

Browse Caterpillar generators & specs →

Procedure

1. 2. Use tool (A) and the lifting device to align the flywheel housing (8) to the dowels (6). Install
2. the flywheel housing to the back plate.
3. 3. Install the nuts (7) and the bolts (not shown) that fasten the back plate (2) to the flywheel
4. housing (8).
5. 4. Install the setscrews (1) that fasten the back plate (2) to the flywheel housing (8).
6. 5. Install the setscrews (5) on each side of the cylinder block. These setscrews fasten the
7. flywheel housing (8) to the cylinder block.
8. 6. Remove the tool (A) and the lifting device from the flywheel housing.
9. 7. Install the setscrews (3) that fasten the flywheel housing (8) to the cylinder block.
10. 8. For C1.5/3013C, C2.2/3024C and C2.2/3024CT engines, tighten the fasteners to a torque of
11. 25 N·m (19 lb ft).
12. End By:
13. a. Install the flywheel. Refer to Disassembly and Assembly, "Flywheel - Install".
14. Installation Procedure (Engines with Flywheel Housing)
15. Table 4

Source: manual:216-Skid-Steer-Loader-Service-Manual-4NZ03400.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.