Caterpillar — Rear Seal - Remove" and Disassembly and Assembly, "Crankshaft Rear Seal - Install".

A Caterpillar service procedure — check it applies to your exact model before use.

Browse Caterpillar generators & specs →

Procedure

1. 2. Use tool (A) and the lifting device to align the flywheel housing (2) to the dowels (5). Install
2. the flywheel housing to the engine.
3. 3. Install the setscrews (1) that fasten the flywheel housing to the cylinder block.
4. For C0.5 and C0.7 engines, tighten the setscrews to a torque of 15 N·m (11 lb ft).
5. For C1.1/3011C and C1.6 engines, tighten the setscrews to a torque of 50 N·m (37 lb ft).
6. For C1.5/3013C engines, tighten the setscrews to a torque of 25 N·m (19 lb ft).
7. 4. Remove tool (A) and the lifting device from the flywheel housing.
8. End By:
9. a. Install the flywheel. Refer to Disassembly and Assembly, "Flywheel - Install".
10. Product: SKID STEER LOADER
11. Model: 216 SKID STEER LOADER 4NZ
12. Configuration: 216 226 232 242 Skid Steer Loader 4NZ03400-UP (MACHINE) POWERED BY 3024C, 3034 Engine
13. Disassembly and Assembly
14. 3024C Engine for Caterpillar Built Machines
15. Media Number -SENR5006-04
16. Publication Date -01/01/2009
17. Date Updated -16/01/2009
18. i01895708
19. Crankshaft Pulley - Remove and Install
20. 1. Loosen the bolts for the alternator and slide the alternator toward the engine.
21. 2. Remove the fan drive belt.
22. Illustration 1
23. g00827213
24. 1. Remove nut (5) and washer (3) from crankshaft pulley (2) .
25. Illustration 2

Source: manual:216-Skid-Steer-Loader-Service-Manual-4NZ03400.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.