Caterpillar — NOTICE

A Caterpillar service procedure — check it applies to your exact model before use.

Browse Caterpillar generators & specs →

Procedure

1. 1. Support the engine with a suitable lifting device or support the engine on blocks that are
2. positioned on a flat level surface.
3. 2. Install tool (A) and a suitable lifting device to the flywheel housing. Support the weight of
4. the housing (8).
5. Illustration 1
6. g00827061
7. Typical example
8. 3. Remove the setscrews (3) that fasten the flywheel housing (8) to the cylinder block.
9. 4. Remove the setscrews (5) on each side of the cylinder block. These setscrews fasten the
10. flywheel housing (8) to the cylinder block.
11. 5. Remove the setscrews (1) that fasten the back plate (2) to the flywheel housing (8).
12. 6. Remove the nuts (7) and the bolts (not shown) that fasten the back plate (2) to the flywheel
13. housing (8).
14. Illustration 2
15. g00826988
16. Typical example
17. 7. Use tool (A) and the lifting device to remove the flywheel housing (8) from the back plate.
18. Removal Procedure (Engines with Flywheel Housing)
19. Table 2
20. Required Tools
21. Tool
22. Part Number
23. Part Description
24. Qty
25. A

Source: manual:216-Skid-Steer-Loader-Service-Manual-4NZ03400.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.