Caterpillar — 2. Install tool (A) and a suitable lifting device to the flywheel housing. Support the weight of

A Caterpillar service procedure — check it applies to your exact model before use.

Browse Caterpillar generators & specs →

Procedure

1. 3. Remove the setscrews (3) that fasten the flywheel housing (8) to the cylinder block.
2. 4. Remove the setscrews (5) on each side of the cylinder block. These setscrews fasten the
3. flywheel housing (8) to the cylinder block.
4. 5. Remove the setscrews (1) that fasten the back plate (2) to the flywheel housing (8).
5. 6. Remove the nuts (7) and the bolts (not shown) that fasten the back plate (2) to the flywheel
6. housing (8).

Source: manual:216-Skid-Steer-Loader-Service-Manual-4NZ03400.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.