Caterpillar C317 — Dash Module Installation (Pre-91)
Installation · Dash control module
For the Caterpillar C317, from the Caterpillar service manual.
Browse Caterpillar generators & specs →
Before you start
- Do not overtighten nuts. Switch failure will result.
Procedure
- Locate an area on the dash for the dash control module and drill a 2 in. hole.
- Install the module and attach the bracket to the back of the module with the two nuts.
- Attach the ribbon harness to the dash control module.
Specs & values
- 2 in. hole
Source: Caterpillar service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.