Home›Repair guides›Caterpillar›Fuel System Primary Filter (Water Separator) Element - Replace

Caterpillar 3412C — Fuel System Primary Filter (Water Separator) Element - Replace

Maintenance · Fuel system primary filter/water separator

For the Caterpillar 3412C, from the Caterpillar owner's manual.

Applies to: Caterpillar 3412C, Caterpillar 3412C engine

Before you start

  • Fuel leaked onto hot surfaces can cause a fire

Parts for this job

Part numbers from the service-parts lists for Caterpillar 3412C, Caterpillar 3412C engine. Verify against your serial number before ordering; some links are affiliate links.

Procedure

  1. Stop engine and turn start switch to OFF.
  2. Shut off the fuel tank supply valve.
  3. Open drain valve to drain fuel from filter case; close.
  4. Remove fuel filter bowl and wash with clean diesel fuel.
  5. Remove fuel filter; clean the gasket sealing surface.
  6. Apply clean diesel fuel to the new fuel filter gasket.
  7. Install new filter; tighten additional 3/4 turn by hand.
  8. Open supply valve; start engine and check for leaks.

Specs & values

  • Change element if vacuum gauge pressure is at 50 to 70 kPa (15 to 20 inches Hg)

Full service-parts list: Caterpillar 3412C →, Caterpillar 3412C engine →

Source: Caterpillar owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Caterpillar repair guides →