Caterpillar 3044C — Alternator and Fan Belts - Inspect/Adjust/Replace
Maintenance
For the Caterpillar 3044C, from the Caterpillar owner's manual.
Browse Caterpillar generators & specs →
Before you start
- If belts too loose, vibration causes wear and slipping may cause overheating.
Procedure
- Inspect belts for wear and cracking. Replace worn or damaged belts.
- For multiple drive belts, replace in matched sets.
- Check belt tension: apply 45 N force midway between pulleys; deflection should be 10 mm.
- Adjust: loosen mounting bolts (1).
- Move alternator (4) to increase or decrease tension.
- Tighten mounting bolts (1).
- Replace: refer to Disassembly and Assembly, V-Belts - Remove and Install.
- After new belts, check tension again after 20 hours.
Tools required
- 45 N force gauge Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- 45 N force
- 10 mm deflection
- 20 hours recheck
Source: Caterpillar owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.