Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Install Governor Actuator

Briggs And Straton — Install Governor Actuator

A Briggs And Straton service procedure — check it applies to your exact model before use.

Browse Briggs And Straton generators & specs →

Before you start

  • Open ends of spring must face cylinder head.

Procedure

  1. Assemble governor link spring and link to actuator lever.
  2. Assemble actuator to mounting bracket loosely. Do not tighten screws.
  3. Rotate throttle lever clockwise to end of travel (throttle closed) and hold in this position.
  4. Slide actuator to align with throttle lever, then tighten screws.

Source: manual:Briggs-Straton_Gas_3Cylinder_Liquid-Cooled_Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.