Aurora — Glow Plug Setting Adjustment

For these Aurora models: DynaGenTM ES52, ES52.

Browse Aurora generators & specs →

Procedure

1. Remove the wires connected to the Timer terminal # 12 and the Crank terminal # 5.
2. Apply power to the Start/Stop terminal # 10.
3. Measure the time that the "Timer" LED remains ON.
4. Remove power from the Start/Stop terminal # 10.
5. Increase or decrease pot setting as required. The pot resolution is 1.6 seconds/turn.
6. Return to step 2 as needed.
7. Re-connect the wires to the Timer terminal # 12 and the Crank terminal # 5.

Source: manual:dynagen-es52-user-manual-en.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.