Aurora Generators ES52 — 10A Diode on Auto/Off/Test Switch on Units with Cool-Down Feature
Installation
For the Aurora Generators ES52, from the Aurora Generators service manual.
Browse Aurora Generators generators & specs →
Procedure
- Applies only to ES52 EI, FE, and LT variants with cool-down feature.
- Install a 10A diode between test and auto with band pointing to auto terminal.
- Diode allows power to auto terminal as well as test terminal when switch is in test position.
- If two-switch configuration is used, Auto Switch must be ON as well as test switch when in test/manual.
Specs & values
- 10A diode required
Source: Aurora Generators service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.