Allmand — Auto Idle Control (Purge Control) Operation
Operation
From a Allmand service manual — check it applies to your exact model before use.
Procedure
- During operation, long push (2 seconds) on AUTO IDLE switch.
- The AUTO IDLE lamp goes on.
- To stop this operation mode, push AUTO IDLE switch again and the lamp goes out.
Specs & values
- Purge releasing pressure primary set value: 86 PSI (range 70 to 100)
- Waiting time for transfer to purge mode operation: 10 sec (range 5 to 60)
Source: Allmand service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.