Allis-Chalmers — Starting Engine Without Starting Aids
Operation
From a Allis-Chalmers owner's manual covering: Series 606, Series 633, Series 649, Series 685. Check it applies to your exact model before use.
Before you start
- If engine is to be started indoors, insure proper ventilation to remove deadly exhaust gases.
Procedure
- Disconnect or remove load from engine.
- Place all controls in START/RUN position.
- Move speed control to full throttle position.
- Turn key to ON position.
- Press and hold starter button; release when engine will run without aid of starter (30 seconds maximum).
- Allow engine to warm up at half throttle.
- Oil pressure should exceed 10 psi (60 kPa) minimum within seconds; after warm-up 30 to 55 psi (207 to 370 kPa) at full load rpm.
Specs & values
- Do not hold starter button down longer than 30 seconds without 2 minutes to cool
Source: Allis-Chalmers owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.