Allis-Chalmers — Fuel Injection Nozzle Holder Removal
Repair & overhaul · Fuel injection nozzle holders
From a Allis-Chalmers owner's manual covering: 11000, 11000 MKIT, 11000MKII, T1Q00GMKII. Check it applies to your exact model before use.
Applies to: Allis-Chalmers 11000 / 11000MKII engine
Before you start
- Do not bend lines when disconnecting. Cover all openings immediately. Use care to avoid striking the nozzle tip against hard objects.
Procedure
- Clean nozzles, lines, connectors and surrounding area thoroughly.
- Remove fuel drip manifold and disconnect injection lines from nozzle holders.
- Remove capscrews and lockwashers securing nozzles to cylinder head.
- Remove nozzles using two small pry bars or a slide hammer with adaptor.
- Remove dust shields; replace if brittle, torn or deteriorated.
Tools required
- Two small pry bars or slide hammer with adaptor Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: Allis-Chalmers 11000 / 11000MKII engine →
Source: Allis-Chalmers owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.