Allis-Chalmers — Filling cooling system
Maintenance
From a Allis-Chalmers operator's manual covering: 16000MKII, 17000MKII, 21000MKII, 25000MKII. Check it applies to your exact model before use.
Procedure
- Close all drain cocks and install all drain plugs removed.
- Check to assure vent cock in top of thermostat housing is open.
- Pour coolant into radiator until it flows from vent cock.
- Close vent cock and continue filling until coolant level is approximately 1-1/2 in below bottom of filler neck.
- Open vent cock at top rear of intercooler; vent air and check level of coolant.
- Install filler cap.
Specs & values
- Coolant level approximately 1-1/2 in below filler neck
Source: Allis-Chalmers operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.