Allis-Chalmers 3500 MK II / SOOMKII 1.5 — Coolant Filter/Conditioner Element Replacement
Maintenance · Cooling system conditioner
For the Allis-Chalmers 3500 MK II / SOOMKII 1.5, from the Allis-Chalmers owner's manual.
Applies to: Allis-Chalmers 3500 MKII engine
Before you start
- Do not use soluble oil or other conditioners in a system equipped with a coolant filter.
Parts for this job
- 4734562 Coolant filter buy
Part numbers from the service-parts list for Allis-Chalmers 3500 MKII engine. Verify against your serial number before ordering; some links are affiliate links.
Procedure
- Thoroughly clean base and surrounding area.
- Close coolant inlet and outlet shutoff valves.
- Remove exhausted spin-on element and discard.
- Lubricate gasket with a thin film of oil.
- Install element until gasket contacts base of mounting housing.
- Hand tighten 1/2 turn more.
- Open inlet and outlet shutoff valves.
- Operate engine and check for leaks.
Specs & values
- Initial element change at 100 hours; then each 600 hours
Full service-parts list: Allis-Chalmers 3500 MKII engine →
Source: Allis-Chalmers owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.