Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›3. Install the fuel inlet valve seat and valve.

NH — 3. Install the fuel inlet valve seat and valve.

For the NH.

Procedure

  1. 4. Install the float and float pin. Center the pin so the float bowl does not ride against it.
  2. 5. Check the float level with the carburetor casting inverted. See Figure 6. Install the bowl ring gasket, bowl and bowl nut.

Source: manual:940-0501_Onan_NH_series_Generator_Major_Service_manual_08-1973.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.