Service parts for the TAD1641VE
Grouped by system, with how many of each the parts manual calls for.
Air intake
1 requiredFuel system
1 requiredOil system
1 requiredPrices captured from merchant listings; some links are affiliate links. Confirm against your serial number before ordering.
Specifications
| Standby power | 440 kW |
|---|---|
| Fuel tank | 8.0 L |
Maintenance & consumables
| Item | Spec | Capacity | Part # | Interval | |
|---|---|---|---|---|---|
| Air filter | Air filter | 7746012 | Amazon eBay | ||
| Fuel filter | Fuel filter | 7746032 | Amazon eBay | ||
| Oil filter | Oil filter | 7746022 | Amazon eBay |
Common questions
How many kW is the Volvo Penta TAD1641VE?
The Volvo Penta TAD1641VE is rated 440 kW standby.
What size fuel tank does the Volvo Penta TAD1641VE have?
The Volvo Penta TAD1641VE has a 8 liter (2 US gallon) fuel tank.
Which oil filter part number does the Volvo Penta TAD1641VE take?
The Volvo Penta TAD1641VE uses oil filter part number 7746022.
Which fuel filter part number does the Volvo Penta TAD1641VE take?
The Volvo Penta TAD1641VE uses fuel filter part number 7746032.
What air filter does the Volvo Penta TAD1641VE use?
The Volvo Penta TAD1641VE uses air filter part number 7746012.
Troubleshooting
6Fault codes
| Code | Meaning | Cause | Remedy |
|---|---|---|---|
| 1.1 | No faults — There are no active faults. | ||
| 2.1 | Water in fuel — Warning lamp lights up. | Water in fuel. | Empty the primary fuel filter. |
| 2.2 | Coolant level — Warning lamp lights up. VE engines: Engine control module reduces engine power (unless the protection has been shut off with the diagnostic tool VODIA). GE engines: Engine is shut off (unless the protection has been shut off with the diagnostic tool VODIA). | Low coolant level | Check the coolant level; Check coolant level monitor function. |
| 2.3 | Coolant level sensor | Short circuit to positive (+); Fault in sensor. | Check that the coolant level sensor cable is not damaged; Check coolant level sensor function; Check contact pressure in sockets 23 and 10 in the upper cable connector (A) on the engine management module. |
| 2.4 | Engine speed sensor, flywheel — Engine is very difficult to start and runs roughly when it starts. | No signal; Abnormal frequency; "Intermittent" signal from the sensor; Fault in sensor. | Check that the sensor connector is correctly installed; Check that the engine speed sensor cable is not damaged; Check that the engine speed sensor is correctly installed in the flywheel housing; Check engine speed sensor function; Check contact pressure in sockets 37 and 38 in the upper cable connector (A) on the engine management module. |
| 2.5 | Speed sensor, camshaft gear — Engine takes longer to start than normal. Engine runs normally when is running. | No signal; Abnormal frequency; Fault in sensor. | Check that the engine speed sensor connector is correctly installed; Check that the engine speed sensor cable is not damaged; Check that the engine speed sensor is correctly installed in the upper timing gear cover; Check engine speed sensor function; Check contact pressure in sockets 45 and 46 in the upper cable connector (A) on the engine management module. |
Fault codes and symptom→remedy steps extracted from this model’s service/owner documentation; verify against the official manual before servicing. Full Volvo Penta TAD1641VE troubleshooting guide (76 entries) →
Parts
4| Part # | Description | Qty | System | |
|---|---|---|---|---|
| 7746012 | Air filter | 1 | Air filter | Amazon eBay |
| 7746022 | Oil filter | 1 | Oil filter | Amazon eBay |
| 7746032 | Fuel filter | 1 | Fuel filter | Amazon eBay |
| 3801605 | Cylinder head | Service part / kit | eBay |
Service, wear & replacement parts referenced for this model and its engine — confirm the exact part for your serial number. See the full parts catalog to search and cross-reference.
Available documents
This page was generated from the 13 manufacturer documents above by automated extraction; every figure shown is copied from one of them. How the data is compiled.