Specifications
Ratings spec sheet not in our library yet — see the documents below.
Maintenance & consumables
| Item | Spec | Capacity | Part # | Interval | |
|---|---|---|---|---|---|
| Fuel filter | Secondary | 278858 | Amazon eBay $30.48 |
Troubleshooting
1| Symptom | Cause | Remedy |
|---|---|---|
| Generator set operates erratically. | D Check the carburetor for dirt, grime, or misadjustment. Also, check the idle-adjustment screw. The screw should not prevent the throttle plate from completely closing. Also, check the throttle linkage for any binding, dirt, damage, etc. D Check electrical connections— check the stepper motor, controller box, and governor connector (inside the controller) for clean and tight connections. D Check electrical ground connections— a good DC ground must be provided to the controller assembly and governor circuit. D Check for a good positive 12-volt DC supply. Also check if the positive voltage supply is unstable or below 8-volts DC making the control unit function erratically. D Check magnetic pickup connections. Poor connections may cause the signal to be erratic. As long as this erratic signal is being sent, the unit will not shut down due to loss of pickup. D Check for dirt buildup on magnetic pickup— metal filings or caked-on dirt/grease may decrease the output signal of the magnetic pickup. D Check for a loose coupling screw. D Check for stepper motor/throttle shaft coupling wear— if the roll pin wore the slot of the stepper motor coupling, loosen coupling screw and move coupling so that roll pin is positioned at a point in stepper motor coupling without wear. Tighten coupling screw. |
Symptom → cause → remedy extracted from this model’s service/owner documentation; verify against the official manual before servicing.