Specifications
Ratings spec sheet not in our library yet — see the documents below.
Filters & service parts
model family| Item | Spec | Capacity | Part # | Interval | |
|---|---|---|---|---|---|
| Air filter | — | ||||
| Fuel filter | — | ||||
| Oil filter | — | 1500 hr | |||
| Battery | — | ||||
| Belt | — | ||||
| Coolant | 84.0 L | — | 250 hr | ||
| Oil | 132.0 L | — | 500 hr | ||
| Spark plug | — |
Compiled from this model's family documentation — may include parts for closely-related variants. Confirm the exact part for your serial number.
Service intervals
5| Item | Action | Hours | Months | Notes |
|---|---|---|---|---|
| Lubricating oil | Test | 250 hr | 6 mo | First service — For high horsepower engines with Eliminator™ oil filter option: take oil samples every 250 hours and analyze per Cummins Engine Oil Recommendations Bulletin 3810340; repeat for at least three oil change intervals. |
| filters | Change | 1000 hr | with CENTINEL, depending on load factors | |
| ELIMINATOR self cleaning filter core | Other | 1500 hr | Requires servicing only every 1,500 hours. Saves up to 90% of lube system maintenance costs and increases productivity. | |
| fuel filter | Change | 1500 hr | Fleetguard NanoNet media | |
| engine oil | Change | 4500 hr | with CENTINEL, railway applications |
Extracted from the manufacturer documentation linked to this model. Values are copied as printed; confirm against your unit's manual and serial number.
Recommended fluids
| Fluid | Grade | Standard | Ambient | Capacity | Notes |
|---|---|---|---|---|---|
| Engine oil | Cummins Engine Oil Recommendations Bulletin 3810340 | Used to analyze oil samples for high horsepower engines with Eliminator™ oil filter option. | |||
| Fuel | B100 biodiesel | ASTM D6751 | Must conform prior to blending; revised to include a cold soak test; stability requirement still in effect. | ||
| Fuel | B20 biodiesel blend | ASTM D7467 | Applies to biodiesel blends B6–B20; includes oxidation stability requirement; replaces Cummins' previous EMA B20 specification requirement. Must be purchased from a BQ9000 Certified Marketer; B100 must be sourced from a BQ9000 Accredited Producer. | ||
| Fuel | B5 biodiesel | All Cummins automotive and industrial engines are compatible with B5 biodiesel. | |||
| Fuel | biodiesel (Europe) | EN 14214 | Published by CEN, European Committee for Standardization. Equivalent biodiesel specifications required internationally. |
Extracted from the manufacturer documentation linked to this model. Values are copied as printed; confirm against your unit's manual and serial number.
Procedures
2Oil sampling for high horsepower engines with Eliminator™ oil filter option maintenance
- Take oil samples every 250 hours of operation.
- Analyze samples according to Cummins Engine Oil Recommendations Bulletin 3810340.
- Repeat for at least three oil change intervals to ensure consistent oil behavior.
Switching from petrodiesel to B20 on used engines maintenance
⚠ B20 has a solvent nature and may clean the vehicle fuel tank and lines.
- Install new fuel filters when switching to B20.
- Replace fuel filters at half the standard interval for the next two fuel filter changes.
- After the initial period, revert to intervals specified in the O & M manual.
- For EPA 2007 on-highway midrange engines, sample oil for the first 6 months to monitor fuel dilution.
Extracted from the manufacturer documentation linked to this model. Values are copied as printed; confirm against your unit's manual and serial number.
Available documents
This page was generated from the 5 manufacturer documents above by automated extraction; every figure shown is copied from one of them. How the data is compiled.