HomeCummins/OnanCummins/Onan DKC

Cummins/Onan DKC Generator Set

The Cummins/Onan DKC is a 4 kW (4 kVA) No. 1, No. 2 Diesel or Blend standby generator set powered by a Cummins/Onan Gasoline 4-cycle engine. It is available at 12 V, 120 V and 120/240 V, 1-phase and 60 Hz. It holds about 3.8 L (1.0 gal) of oil and 2.6 L (0.7 gal) of coolant. Starting uses 1 battery rated 425 CCA at 12 V. The set weighs about 475 kg (1047 lb).

4 kW
Standby
3.8 L
Oil capacity
2
Document types

How to read your Cummins/Onan serial & model number →

Specifications

FuelNo. 1, No. 2 Diesel or Blend
Frequency60.0 Hz
Standby power4 kW
Standby kVA4
Oil capacity3.8 L
AlternatorCummins/Onan Generator
Voltage options12 V, 120 V, 120/240 V
Phase1 or 3
Battery cranking425 CCA
Battery voltage12 V
Battery quantity1
Coolant capacity2.6 L
Dry weight475 kg

Engine

Cummins/Onan Gasoline 4-cycle
AspirationNaturally aspirated

Maintenance & consumables

for the Cummins/Onan Gasoline 4-cycle
ItemSpecCapacityPart #Interval
Air filterAir filter element find
Fuel filterFuel filter element find
Oil filterOil filter element find
BeltDrive belt - water pump find
CoolantEngine coolant

Common questions

What is the power rating of the Cummins/Onan DKC?

The Cummins/Onan DKC is rated 4 kW standby (4.0 kVA).

What engine does the Cummins/Onan DKC use?

The Cummins/Onan DKC is powered by the Cummins/Onan Gasoline 4-cycle engine.

What fuel does the Cummins/Onan DKC use?

The Cummins/Onan DKC runs on No. 1, No. 2 Diesel or Blend.

What alternator does the Cummins/Onan DKC use?

The Cummins/Onan DKC uses a Cummins/Onan Generator alternator.

Troubleshooting

2

Fault codes

CodeMeaningCauseRemedy
LOW OIL PRESSUREThe DC control has sensors that continuously monitor the engine for abnormal conditions such as low oil pressure and high coolant temperature. If one of these conditions occur, the control stops the engine.If low, add oil to bring level up to full mark. Inspect engine exterior for leaks and repair as necessary. Be sure the correct viscosity oil is used for existing ambient temperature (see Maintenance section). The oil pressure switch actuates the fault circuit if pressure drops below 9 psi (62 kPa).Remove the dipstick and check oil level. If low, add oil to bring level up to full mark. Inspect engine exterior for leaks and repair as necessary. Be sure the correct viscosity oil is used for existing ambient temperature.
HIGH COOLANT TEMPERATUREThe coolant temperature switch closes at 250°F (121°C) and actuates the fault circuit.Check the coolant level in radiator after allowing engine to cool down. Ensure the pump belt is okay and has proper tension. Also check cooling system cleanliness (freedom from contaminants, rust, sludge build-up, etc.).Check the coolant level in radiator after allowing engine to cool down. Ensure the pump belt is okay and has proper tension. Also check cooling system cleanliness.

Fault codes and symptom→remedy steps extracted from this model’s service/owner documentation; verify against the official manual before servicing.

Parts

20
Part #DescriptionQtySystem
185-2115Pump, oil1Pump PartsGeek
185-2217Gasket, cylinder head valve cover1Gasket PartsGeek
185-2232Element, breather1Air filter PartsGeek
185-2291Seal, oil3Seal PartsGeek
185-2349O-Ring1Seal PartsGeek
193-0318Sender, temperature - engine coolant1Sensor PartsGeek
185-2000Crankcase block1Service part / kit PartsGeek
185-2003Crankshaft standard3Service part / kit PartsGeek
185-2015Ring, piston standard3Service part / kit PartsGeek
185-2016Pin, piston6Service part / kit PartsGeek
185-2064Valve, inlet3Service part / kit PartsGeek
185-2065Valve, exhaust3Service part / kit PartsGeek
185-2079Spring, compression6Service part / kit PartsGeek
185-2093Cap, oil fill1Service part / kit PartsGeek
185-2094Cock, drain1Service part / kit PartsGeek
185-2230Baffle, breather1Service part / kit PartsGeek
185-2280Valve cover, cylinder head1Service part / kit PartsGeek
185-2287Plate, breather1Service part / kit PartsGeek
185-2290Nut, cap3Service part / kit PartsGeek
981-0625Generator Set7Service part / kit PartsGeek

Service, wear & replacement parts referenced for this model and its engine — confirm the exact part for your serial number. See the full parts catalog to search and cross-reference.

Fuel consumption

RatingLoadL/hgal/h
Prime
Standby

Available documents

Parts manual — 0932-0112 Onan Post-Sale Literature Index (07-1998) (Cummins/Onan)Parts manual — 981-0221 Onan DKC Parts Manual (8-1990) (Cummins/Onan)Service manual — 981-0625 Onan DKC DKD Aux Installation Manual (7-1991) (Cummins/Onan)