Service parts for the HRN216
Grouped by system, with how many of each the parts manual calls for.
Air intake
1 requiredElectrical
1 requiredPrices captured from merchant listings; some links are affiliate links. Confirm against your serial number before ordering.
Specifications
Ratings spec sheet not in our library yet — see the documents below.
Maintenance & consumables
| Item | Spec | Capacity | Part # | Interval | |
|---|---|---|---|---|---|
| Air filter | Carburetor float level gauge | 07401-0010000 | Amazon eBay | ||
| Fuel filter | — | ||||
| Oil filter | — | ||||
| Battery | Charge the battery for 24 hours using PN 06320-VH7-UA2 charger and replace if necessary (P. 11-27) | 06320-VH7-UA2 | Amazon eBay $199.99 | ||
| Belt | — | ||||
| Coolant filter | — | ||||
| Spark plug | — |
Common questions
Which air filter part number does the Craftsman Marine HRN216 take?
The Craftsman Marine HRN216 uses air filter part number 07401-0010000.
Troubleshooting
7Symptoms & remedies
| Symptom | Cause | Remedy |
|---|---|---|
| Hard Starting Using Recoil Starter Or Poor Engine Performance | Sufficient fuel in tank • Install a new spark plug, then restart the engine. • Check the carburetor for flooding. • Check the ignition coil air gap (P. 9-6). Check the valve clearance (P. 3-15), and then perform the cylinder compression test. If the cylinder compression is still too low, perform a leak down test. If the air leak down test shows air leakage, check the following as determined by the test: - Valve sticking open (P. 3-15) - Valve seat width (P. 10-31) - Carbon on the valve seat (P. 10-31) - Piston ring side clearance (P. 10-25) - Piston ring width (P. 10-25) - Piston ring end gap (P. 10-25) - Piston skirt O.D. (P. 10-24) - Cylinder sleeve I.D. (P. 10-24) | |
| No fuel in tank | Dry Wet Remove the spark plug and inspect (P. 3-8). Good spark No or weak spark Install a compression gauge in the spark plug hole (P. 2-13) and briskly crank the engine repeatedly until a stabilized reading is obtained. Install the spark plug in the plug cap and perform the spark test (P. 2-13). | |
| Stale fuel | See “CHOKE CONTROL SYSTEM” on page 2-15. | |
| Compression is above 80 psi | Camshaft decompressor is not working, valve clearance excessive, or damaged rocker arm. Inspect the decompressor (page P. 10-23). | |
| Electric Starter Will Not Operate | Less than 12.7 V | Charge the battery for 24 hours with PN 06320-VH7-UA2 charger and replace if necessary (P. 11-27). Check the wire harness. Replace the fuse (P. 11-28). Check the starter key switch and replace if necessary (P. 11-28). |
| Engine cranks slowly or not at all | Less than 12.7 V | Charge the battery for 24 hours using PN 06320-VH7-UA2 charger. |
| Battery Has Low Voltage (less than 12.7 V) | Less than 0.5 mm | Replace the wire. Stop the engine and check the charge coil air gap (0.3 ~ 0.5 mm) (P. 9-6). |
Fault codes and symptom→remedy steps extracted from this model’s service/owner documentation; verify against the official manual before servicing.
Parts
7| Part # | Description | Qty | System | |
|---|---|---|---|---|
| 07401-0010000 | Carburetor float level gauge | Air filter | Amazon eBay | |
| 07908-KE90200 | Valve adjustment wrench, 3 mm | Tool | Amazon eBay | |
| 07AAJ-E85A100 | Fuel Alcohol tester | Tool | Amazon eBay | |
| 07JPZ-001010B | Jet cleaner | Tool | Amazon eBay | |
| EEPV503 | Compression gauge | Tool | Amazon eBay | |
| FFL-72-520-300 | Dial indicator, commercially available | Tool | Amazon eBay | |
| FFL-72-585-010 | Magnetic base, commercially available | Tool | Amazon eBay |
Service, wear & replacement parts referenced for this model and its engine — confirm the exact part for your serial number. See the full parts catalog to search and cross-reference.