Waukesha F1197-GRS1U Engine

The cheapest captured merchant offer per filter — see the full cross-reference below for every OEM/aftermarket option.

Prices captured from merchant listings; some links are affiliate links. Verify against your serial number before ordering.

This engine also powers 7 machine(s) on Power Equipment Info.

• Partial loss of residual in Rotor
  Fix: With plant operating, jumper from E2 to heat sink of field rectifier Z until voltage begins to build-up. Then remove.
• Output voltage slow to buildup.
  Cause: Circuit breaker opens in about five seconds
• Output voltage slow to build up and ten to twenty percent above rated voltage after build up
  Cause: Open in one Field Rectifier or Open circuit in Gate winding G1-G2 of Reactor A or B
  Fix: Test rectifiers and replace if defective. If Field Rectifiers Y and Z check okay, check continuities of Gate windings G1-G2
• Output voltage slow to build up and higher than rated voltage after build up
  Cause: Open circuit in one or more Control Rectifier
  Fix: Test rectifier and replace if defective. Check soldered connections to rectifiers
• Output voltage slow to build up and five percent below rated voltage after build up. Voltage regulation poor.
  Cause: Either Field Rectifier W or Z shorted
  Fix: Test rectifiers and replace if defective
• Output voltage builds up normally with slightly less than rated voltage at no load and low voltage at full load
  Cause: Compound winding S1-S2 installed backward or has open circuit
  Fix: Check wiring diagram for polarity of compound windings through Reactors A and B and test for continuity
• Output voltage builds up normally but less than rated voltage after build up
  Cause: Shorted winding in Control Reactor
  Fix: Test Control Reactor and replace if defective
• Output voltage builds up normally but is twenty-five percent above rated voltage after build up
  Cause: Open circuit in Control Rectifier bridge
  Fix: Check continuity from the junction of Control Rectifiers W and X to the junction of Control Rectifiers Y and Z
• Output voltage builds up normally but 20-percent above rated voltage after build up. Voltage regulation poor.
  Cause: Compound winding S1-S2 installed backward through one Reactor (A or B))
  Fix: Check wiring diagram for polarity of Compound winding through Reactor A or B
• No AC power to Magneciter
  Fix: Check AC voltage at E1-E2 with the plant operating. Voltage should be five percent of the rated voltage. If not, check continuity from E1-E2 back to generator
• Generator will not build up voltage.
  Cause: Circuit breaker in 'off' or 'tripped' position
  Fix: Reset and close breaker
• Excessive charging rate (Battery requires too frequent filling)
  Fix: Tighten connections,
• Alternator fails to charge or puts out low or unstable charge rate
  Cause: Alternator belt loose. Loose or dirty battery connections. Worn or defective brushes. Faulty regulator.
  Fix: Tighten belt. Clean and tighten. Replace brushes. Replace regulator.

Compiled from service & troubleshooting documentation across every generator set that uses the Waukesha F1197-GRS1U.

Pooled from every document that names this exact engine — confirm the interval and part number against your unit's serial number.

• Oil filter: Waukesha 101737A Donaldson P550117 Wix 51503 Ac Delco AC114

Cross-referenced via Donaldson + OEM/engine-maker interchange — options to verify against your serial number, not confirmed for every exact variant.

• Waukesha F1197G — Engine

Other equipment known to use this engine, via filter-application cross-reference — useful for sourcing parts even when your exact machine isn't listed elsewhere on this page.