Maintenance schedule
| Item | Spec | Capacity | Part # | Interval | |
|---|---|---|---|---|---|
| Air filter | Gasoline fueled sets are equipped with an oil bath air cleaner. Service the air cleaner with oil, filling to the level marks on the cleaner. Use the same SAE number as used in the crankcase. However, if air cleaner renewal is likely to be frequent, it is not necessary to use expensive heavy duty oil in the air cleaner. A straight non-detergent mineral oil is satisfactory. | — | 40 hr | ||
| Fuel filter | — | 42 hr | |||
| Oil filter | — | 100 hr | |||
| Battery | Ensure that the cable connections to the batteries are secure. Coat connections with petroleum based or non-conductive grease to retard formation of corrosive deposits. | — | 40 hr | ||
| Belt | — | ||||
| Coolant | Cooling system was drained prior to shipment. Fill cooling system before starting. Nominal capacity is 10 gallons (22 liters). For units using either a radiator or heat exchanger (city water cooled), fill the system with clean soft water. Use a good rust and scale inhibitor additive. If a possibility exists of a radiator cooled set being exposed to freezing temperatures use anti-freeze with an ethylene-glycol base. During initial engine run, check the coolant level several times and replenish if necessary to compensate for air pockets which may have formed during filling. | 22.0 liters | — | ||
| Coolant filter | — | ||||
| Oil | Lubrication System: Engine oil was drained prior to shipment. Fill engine to capacities shown. After engine has been run, check dipstick, add oil to bring level to full mark. Record total capacity for future oil changes. Do not mix brands nor grades of lubricating oils. | — | 100 hr | ||
| Spark plug | Check all connections in fuel system for security, to ensure that pressure will not bleed off when engine is not in use. Pressure should be maintained for immediate starting if unit is on standby service. | — | 125 hr |
Pooled from every document that names this exact engine — confirm the interval and part number against your unit's serial number.