Cummins/Onan 06110TA Engine Engine

• Undedicated fault. May be factory programmed as a shutdown or non-shutdown, and as a timed or non-timed fault. (Normally set for timed shutdown). FAULT 1 (red)
• Starter has been locked out because of excessive cranking time
  Cause: OVERCRANK (red) indicates the starter has been locked out because of excessive cranking time.
• Same features as Fault 1 (Normally set for non-timed shutdown). FAULT 2 (red)
• Run lamp is not on when generator set is operating.
  Fix: Indicates that a starter disconnect function is not working. Contact an Onan Distributor.
• Run lamp is not on when generator set is operating
  Fix: Indicates that a starter disconnect function is not working. Contact an Onan Distributor.
• Overspeed shutdown.
  Fix: Contact an Onan Distributor.
• Overspeed shutdown
  Fix: Contact an Onan Distributor
• Overcrank fault lamp lights and engine stops cranking after about 75 seconds. Overcrank
  Fix: Check for empty fuel tank, empty fuel filters, system leaks, or plugged fuel filters and fuel supply lines. Correct as required.
• Low oil pressure shutdown; or pre low oil pressure shutdown if so programmed.
  Fix: Check oil level and replenish if necessary. Contact an Onan Distributor if oil level is correct.
• Low fuel fault circuit is energized yellow lamp
  Fix: Check fuel tank and replenish fuel as needed. If fuel in tank is adequate/full, contact an Onan Distributor.
• Low fuel fault circuit (yellow lamp) is energized.
  Fix: Check fuel tank and replenish fuel as needed. If fuel in tank is adequate/full, contact an Onan Distributor.
• Low engine temperature fault circuit is energized yellow lamp
  Cause: Power outage or power disconnect (blown fuses)
  Fix: Check power source supplying the coolant heater. If coolant heater, sensor or engine monitor is suspected, contact an Onan Distributor.
• Low engine temperature fault circuit (yellow lamp) is energized.
  Fix: Check power source supplying the coolant heater. Problem might be a power outage or power disconnect (blown fuses). If coolant heater, sensor or engine monitor is suspected, contact an Onan Distributor.
• High engine temperature shutdown; or pre high engine temperature shutdown if so programmed.
  Fix: Check coolant level on radiator and heat exchanger sets and replenish if necessary. Check for slipping drive belts or for obstructions to the airflow. Contact an Onan Distributor if none of the above.
• Fault lamp lights, no fault exists.
  Cause: Engine monitor or sensor malfunction. Contact an Onan Distributor.

Compiled from service & troubleshooting documentation across every generator set that uses the Cummins/Onan 06110TA.