Cummins/Onan GS130-DG-A-2-3 Engine
The Cummins/Onan GS130-DG-A-2-3 is a 0.13 L naturally_aspirated engine rated at 3000 rpm. It powers generator sets from Cummins/Onan, including the K1000, K1200 and K800. It holds 0.55 L (0.1 gal) of oil.
Also known as: Onan GS130-DG-A-2-3
Engine specifications
| Oil capacity | 0.55 L |
|---|
| Displacement | 0.13 L |
|---|
| Aspiration | naturally_aspirated |
|---|
| Rated speed | 3000 rpm |
|---|
Common problems
7- Only slight output voltage is delivered (3 ~ 6V)
Cause: Worn brush or faulty contact surface of slip ring
Fix: Clean brush contact and slip ring, or replace brush - Rated output voltage is not available
Cause: Abnormal load circuit, blown circuit breaker (S.T.D., voltage 10%)
Fix: Remove abnormality in load circuit and replace fuse - Pilot lamp does not light and output voltage is OV
Cause: Faulty contact of receptacles or disconnected wiring inside of control box
Fix: Repair or replace - Output voltage is not delivered
Cause: Disconnected wiring
Fix: Repair or replace stator coil, demagnetization of permanent magnet, clean brush contact and slip ring, repair or replace brush, or repair or replace sub coil - Output voltage is more than S.T.D. voltage by 30%
Cause: Defective AVR
Fix: Replace - Output voltage OV
Fix: Set the switch to the desired AC or DC position - Fluctuation of engine revolution is abnormal
Cause: Disconnected or punctured AVR capacitor, faulty brush contact, excessive initial current, low engine output, faulty engine governor
Fix: Replace capacitor, check for wear, wear amount, and contamination of contacting surface of brush and clean if necessary, repair or replace
Compiled from service & troubleshooting documentation across every generator set that uses the Cummins/Onan GS130-DG-A-2-3.
Common questions
What is the oil capacity of the Cummins/Onan GS130-DG-A-2-3?
The Cummins/Onan GS130-DG-A-2-3 engine has an oil capacity of 0.55 liters.
What is the displacement of the Cummins/Onan GS130-DG-A-2-3?
The Cummins/Onan GS130-DG-A-2-3 has a displacement of 0.13 liters.
Which generators use the Cummins/Onan GS130-DG-A-2-3 engine?
The Cummins/Onan GS130-DG-A-2-3 powers 3 generator set(s), including Cummins/Onan K1000, Cummins/Onan K1200, Cummins/Onan K800.
What is a common problem with the Cummins/Onan GS130-DG-A-2-3 engine?
A commonly reported issue on generators using the Cummins/Onan GS130-DG-A-2-3 is: Only slight output voltage is delivered (3 ~ 6V). Cause: Worn brush or faulty contact surface of slip ring. Fix: Clean brush contact and slip ring, or replace brush.