HomeEnginesKubota V1200-B

Kubota V1200-B Engine Engine

The Kubota V1200-B is a 1.24 L 4-cylinder engine. It powers generator sets from Cummins/Onan, including the DK.

Also known as: Kubota V1200-B

1.237 L
Displacement
4
Cylinders

Engine specifications

Displacement1.237 L
Cylinders4

Generator sets powered by this engine

1

Common problems

3
  • Engine starts but stops after running several seconds.
    Fix: Check for a possible fault condition. If none, check fault monitors S1 through S4 and fault breaker CB12 for improper wiring. Is a fault condition indicated by fault breaker CB12 on control panel? No: Check for closing of S6 power latch switch. If okay, replace engine monitor PC board. Does latching relay A11-K12 energize and contacts close when generator set comes up to operating speed? Yes: Check all B+ wiring for shorts to ground. Does DC control breaker trip after generator set is started?
  • Engine does not crank.
    Fix: Check battery cables for clean tight connections (refer Checkout [BI). Check B1 starter solenoid and motor-if bad, repair or replace. Jumper battery cable B+ connection to B1 starter salenoid terminal. Does engine crank? Yes: Check B+ wiring to S11. and between S11 and K11. Check NC contacts of A1-K15 and K16 Replace if bad. With S11 in Start position, is battery voltage present between K11 terminal S and ground?
  • Engine cranks but does not start.
    Fix: Check fuel system: fuel tank level, shut-off valves, fuel lines and connections, fuel filters, fuel pump and injection pump. Okay? No: Is K1 fuel solenoid and E5 fuel pump energize when S11 is in Start position? No: Is battery B+ applied to glow plug heaters when Preheat Switch is closed? Yes: Check B+ circuit to K14 coil. Test relay K14 per Checkout [E]. Test K1 fuel solenoid per Checkout [F]. No: Incorrect fuel? See Operator’s Manual recommendations. K13 per Checkouts [GI and [E]. Check heater wiring.

Compiled from service & troubleshooting documentation across every generator set that uses the Kubota V1200-B.

Maintenance schedule

ItemSpecCapacityPart #Interval
Air filterChange the air cleaner yearly, or more often in extremely dusty conditions. find
Fuel filterSee the Periodic Maintenance Schedule for the filter change interval. However, if the engine shows signs of fuel starvation (reduced power or surging), change the fuel filter as follows: 1. Loosen drain and bleed screws. Collect fuel in suitable container. Remove bleed plug. See Figure 9.1522143081 PartsGeek FridayParts $15.69
Oil filterReplace the pressure cap every two years, or sooner if it malfunctions.1584132431 PartsGeek $10.97
BeltTo adjust the belt, loosen the bolt that passes through the long slot in the alternator mounting bracket and slide the alternator until the tension is right. See Figure 7. find
CoolantCheck coolant level in radiator after allowing engine to cool down. Ensure pump belt is OK and has proper tension. Also check cooling system cleanliness (freedom from contaminants, rust, sludge buildup, etc.).
OilMaintain the lubricating qualities of No. 2 diesel fuel should protect the cylinders of a diesel engine at least 30 days when the set is not being run.5.0 quarts (4.7 liters)

Pooled from every document that names this exact engine — confirm the interval and part number against your unit's serial number.

Aftermarket parts that fit this engine

27

Parts listed by aftermarket suppliers as fitting this engine — leads compiled from supplier catalogs; verify the exact part for your serial number.

Filters for this engine

  • Fuel filter: Kubota 1522143081 Donaldson P550127 Wix 33390 Ac Delco TP1200
  • Fuel filter (primary): Kubota 1522143081 Donaldson P550127 Wix 33390 Ac Delco TP1200
  • Oil filter: Kubota 1584132431 Donaldson P550726 Wix 51064

Cross-referenced via Donaldson + OEM/engine-maker interchange — options to verify against your serial number, not confirmed for every exact variant.

Also used in

1
  • Reform-Werke 2003 — Tractor

Other equipment known to use this engine, via filter-application cross-reference — useful for sourcing parts even when your exact machine isn't listed elsewhere on this page.

Common questions

What is the displacement of the Kubota V1200-B?

The Kubota V1200-B has a displacement of 1.237 liters with 4 cylinders.

Which generators use the Kubota V1200-B engine?

The Kubota V1200-B powers 1 generator set(s), including Cummins/Onan DK.

What oil filter does the Kubota V1200-B use?

The Kubota V1200-B uses oil filter part numbers Kubota 1584132431, Donaldson P550726, Wix 51064.

What fuel filter does the Kubota V1200-B use?

The Kubota V1200-B uses fuel filter part numbers Kubota 1522143081, Donaldson P550127, Wix 33390.

What is a common problem with the Kubota V1200-B engine?

A commonly reported issue on generators using the Kubota V1200-B is: Engine starts but stops after running several seconds.. Fix: Check for a possible fault condition. If none, check fault monitors S1 through S4 and fault breaker CB12 for improper wiring. Is a fault condition indicated by fault breaker CB12 on control panel? No: Check for closing of S6 power latch switch. If okay, replace engine monitor PC board. Does latching relay A11-K12 energize and contacts close when generator set comes up to operating speed? Yes: Check all B+ wiring for shorts to ground. Does DC control breaker trip after generator set is started?.