HomeEnginesCummins/Onan ISX15 CM2350 X101

Cummins/Onan ISX15 CM2350 X101 Engine Engine

The Cummins/Onan ISX15 CM2350 X101 is a 4-cylinder engine. It powers generator sets from Cummins/Onan, including the QSF3.8 CM2350 F107.

Also known as: Cummins ISX15 CM2350 X101

4
Cylinders

Engine specifications

Cylinders4

Generator sets powered by this engine

1
Cummins/Onan QSF3.8 CM2350 F107

Common problems

10
  • Wait-to-Start 400040
    Fix: Wait for the Wait-to-Start lamp to turn off before starting the engine
  • OEM engine protection system is malfunctioning
    Fix: STEP 6: Isolate the OEM engine protection system. Follow the OEM service manual instructions to check for a malfunction.
  • Moisture in the wiring harness connectors
    Fix: STEP 5: Dry the connectors with Cummins® electrical contact cleaner, Part Number 3824510. Refer to equipment manufacturer service information.
  • Low Oil Pressure 11000252
    Fix: Shut off the engine immediately to avoid damage
  • Engine Starts But Will Not Keep Running
    Cause: Fuel level is low in the tank, Battery voltage supply to the control module (ECM) is low, interrupted, or open, Idle speed is set too low for accessories, Engine-driven units are engaged
    Fix: Fill the supply tank. Check the battery connections. Adjust the low-idle screw. Disengage engine-driven units.
  • Engine Shuts Off Unexpectedly or Dies During Deceleration
    Fix: STEP 4: Refer to the Engine Difficult to Start or Will Not Start troubleshooting symptom tree in Section TS.
  • Engine Runs Rough or Misfires
    Fix: STEP 4: Allow the engine to warm to operating temperature. If the engine will not reach operating temperature, refer to the Coolant Temperature ig Below Normal troubleshooting symptom tree in Section TS.
  • Engine Runs Rough at Idle
    Cause: STEP 4: Allow the engine to warm to operating temperature. If the engine will not reach operating temperature, refer to the Coolant Temperature ig Below Normal troubleshooting symptom tree in Section TS.
  • Battery voltage supply to the engine control module (ECM) is low, interrupted, or open
    Fix: STEP 7: Check the battery connections, the fuses, and the unswitched battery supply circuit. Refer to equipment manufacturer service information.
  • Air in the fuel system
    Fix: STEP 8: Check for air in the fuel system. Tighten or replace the fuel connections, fuel lines, fuel tank standpipe, and fuel filters as necessary.

Compiled from service & troubleshooting documentation across every generator set that uses the Cummins/Onan ISX15 CM2350 X101.

Maintenance schedule

ItemSpecCapacityPart #Interval
Air filter1000 hr find
Fuel filter2000 hr find
Oil filter089001181000 hr PartsGeek
Belt3163524500 hr PartsGeek
Coolant
Coolant filter08900101500 hr PartsGeek
Hydraulic filter find
Oil100 hr

Pooled from every document that names this exact engine — confirm the interval and part number against your unit's serial number.

Common questions

Which generators use the Cummins/Onan ISX15 CM2350 X101 engine?

The Cummins/Onan ISX15 CM2350 X101 powers 1 generator set(s), including Cummins/Onan QSF3.8 CM2350 F107.

How often should you change the oil in the Cummins/Onan ISX15 CM2350 X101?

The Cummins/Onan ISX15 CM2350 X101 oil change interval is every 100 hours.

What is a common problem with the Cummins/Onan ISX15 CM2350 X101 engine?

A commonly reported issue on generators using the Cummins/Onan ISX15 CM2350 X101 is: Wait-to-Start. Fix: Wait for the Wait-to-Start lamp to turn off before starting the engine.