HomeEnginesGenerac GT-990

Generac GT-990 Engine Engine

The Generac GT-990 is a 0.99 L 2-cylinder air-cooled engine rated at 3600 rpm, producing up to 18.6 kW. It powers generator sets from Generac and Power Systems, including the 12k, GT-530, GTV-760 and Guardian 12 kW. It holds 1.61 L (0.4 gal) of oil.

Also known as: GT-990, Generac GT-990

0.992 L
Displacement
2
Cylinders
3600 rpm
Rated speed
18 kW
Gross power

Engine specifications

Oil capacity1.61 L
Displacement0.992 L
Cylinders2
AspirationAir-cooled
Rated speed3600 rpm
Gross power18 kW

Generator sets powered by this engine

9

Shared across brands: Generac, Power Systems

This engine also powers 35 machine(s) on Power Equipment Info.

Troubleshooting

4

Symptoms & remedies

SymptomRemedy
Generator Produces Zero Voltage or Residual VoltageTEST 4 - PERFORM FIXED EXCITATION / ROTOR AMP DRAW PERFORM STATOR INSULATION RESISTANCE TEST - SECTION 1.4 PERFORM ROTOR INSULATION RESISTANCE TEST - SECTION 1.4 TEST 7 - TEST STATOR TEST 5 - WIRE CONTINUITY TEST 6 - FIELD BOOST TEST 8 - CHECK ROTOR CIRCUIT REPAIR OR REPLACE FUSES
Generator Produces Low Voltage at No-LoadTEST 11 - CHECK AC OUTPUT FREQUENCY TEST 12 - ADJUST ENGINE GOVERNOR TEST 12A - CHECK STEPPER MOTOR CONTROL TEST 2 - CHECK AC OUTPUT VOLTAGE TEST 13- ADJUST VOLTAGE REGULATOR
Generator Produces High Voltage at No-LoadREPLACE DEFECTIVE VOLTAGE REGULATOR
Voltage and Frequency Drop Excessively When Loads are AppliedTEST 14 - CHECK VOLTAGE AND FREQUENCY UNDER LOAD TEST 79 - CHECK IDLE CONTROL TRANSFORMER TEST 80 - CHECK LC1 & LC2 WIRING TEST 81 - CHECK IDLE CONTROL TRANSFORMER PRIMARY WIRING TEST 15 - CHECK FOR OVERLOAD CONDITION TEST 12 - CHECK AND ADJUST ENGINE GOVERNOR

Fault codes and symptom→remedy steps extracted from this engine’s service/owner documentation; verify against the official manual before servicing.

Aftermarket parts that fit this engine

10

Parts listed by aftermarket suppliers as fitting this engine — leads compiled from supplier catalogs; verify the exact part for your serial number.

Common questions

What is the oil capacity of the Generac GT-990?

The Generac GT-990 engine has an oil capacity of 1.61 liters.

What is the displacement of the Generac GT-990?

The Generac GT-990 has a displacement of 0.992 liters with 2 cylinders.

Which generators use the Generac GT-990 engine?

The Generac GT-990 powers 9 generator set(s), including Generac 12k, Generac GT-530, Generac GTV-760, Generac Guardian 12 kW, Generac Guardian 15 kW.