The 8361 SRi 26 is a supercharged engine. It powers generator sets from Himoinsa, including the HIW-210.
Also known as: 8361 SRi 26
| Aspiration | supercharged |
|---|
| Item | Spec | Capacity | Part # | Interval | |
|---|---|---|---|---|---|
| Air filter | — | ||||
| Fuel filter | — | 500 hr | |||
| Oil filter | — | 500 hr | |||
| Battery | service battery | — | 500 hr | ||
| Belt | replace fan and alternator belts | — | 2000 hr | ||
| Coolant | flush and refill | — | 2000 hr | ||
| Oil | — | 500 hr |
Pooled from every document that names this exact engine — confirm the interval and part number against your unit's serial number.
| Item | Action | Hours | Months | Notes |
|---|---|---|---|---|
| Engine Oil and Oil Filter | Change | 500 hr | 12 mo | First service — During engine break-in, change the oil and filter for the first time before 100 hours of operation |
| Air Intake Hoses, Connections, & System | Check | 500 hr | 12 mo | interval column not resolvable from source |
| Automatic Belt Tensioner and Belt Wear | Check | 500 hr | 12 mo | interval column not resolvable from source |
| Battery | Other | 500 hr | 12 mo | Service Battery; interval column not resolvable from source |
| Coolant Solution Analysis - Add SCAs as required | Other | 500 hr | 12 mo | interval column not resolvable from source |
| Cooling System | Check | 500 hr | 12 mo | interval column not resolvable from source |
| Crankcase Vent System | Check | 500 hr | 12 mo | interval column not resolvable from source |
| Engine Electrical Ground Connection | Check | 500 hr | 12 mo | interval column not resolvable from source |
| Engine Mounts | Check | 500 hr | 12 mo | interval column not resolvable from source |
| Fuel Filter Elements | Replace | 500 hr | 12 mo | interval column not resolvable from source |
| Manual Belt Tensioner and Belt Wear | Check | 500 hr | 12 mo | interval column not resolvable from source |
| Cooling System (Flush and Refill) | Change | 2000 hr | 24 mo | Flush and Refill Cooling System; interval column not resolvable from source |
| Cooling System (Pressure Test) | Test | 2000 hr | 24 mo | Pressure Test Cooling System; interval column not resolvable from source |
| Engine Valve Clearance | Adjust | 2000 hr | 24 mo | Check and Adjust Engine Valve Clearance; interval column not resolvable from source |
| Fan and Alternator Belts | Replace | 2000 hr | 24 mo | interval column not resolvable from source |
| Thermostats | Test | 2000 hr | 24 mo | interval column not resolvable from source |
| Standby generator set exercise | Other | 1 mo | Standby generator set must be exercised at least once per month at a minimum of 70% load for one hour |
Extracted from the manufacturer documentation linked to this model. Values are copied as printed; confirm against your unit's manual and serial number.
| Type | Item | Value | Unit | Condition |
|---|---|---|---|---|
| Clearance | Minimum clearance around generator set | 5 | ft (1.5m) | |
| Other | Ground conductor minimum section (bare copper) | 16 | mm2 | |
| Other | Ground conductor minimum section (galvanized iron) | 50 | mm2 | |
| Pressure | Exhaust backpressure limit (aspirated engines) | 800 | mm H2O | |
| Pressure | Exhaust backpressure limit (supercharged engines) | 400 | mm H2O | |
| Resistance | Ground conductor resistance including contact resistance (max) | 0.15 | Ohm |
Extracted from the manufacturer documentation linked to this model. Values are copied as printed; confirm against your unit's manual and serial number.
| Fluid | Grade | Standard | Ambient | Capacity | Notes |
|---|---|---|---|---|---|
| Engine oil | ACEA-E7 or ACEA E6 | If recommended engine oils are not used, the oil and filter change interval is reduced. If diesel fuel sulfur content is greater than 0.05%, the oil and filter change interval is also reduced. | |||
| Fuel | diesel | Diesel fuel with sulfur content greater than 0.05% reduces oil and filter change interval |
Extracted from the manufacturer documentation linked to this model. Values are copied as printed; confirm against your unit's manual and serial number.
| Code | Name | Meaning | Severity | Action |
|---|---|---|---|---|
| AUXILIARY INPUTS | Auxiliary Inputs | Auxiliary inputs can be user configured and will display the message as written by the user. | Warning | |
| BATTERY OVER VOLTAGE | Battery Over Voltage | The DC supply has risen above the high volts setting level for the duration of the high battery volts timer. | Warning | |
| BATTERY UNDER VOLTAGE | Battery Under Voltage | The DC supply has fallen below the low volts setting level for the duration of the low battery volts timer. | Warning | |
| CAN ECU ERROR | CAN ECU Error | The engine ECU has detected a warning alarm and has informed the DSE module. The exact error is also indicated on the module's display. | Warning | |
| CHARGE FAILURE | Charge Failure | The auxiliary charge alternator voltage is low as measured from the W/L terminal. | Warning | |
| EARTH FAULT | Earth Fault | The measured Earth Fault Current has been in excess of the earth fault trip and has surpassed the IDMT curve of the Earth Fault alarm (DSE7310 V2.0 or above only). | Warning | |
| ECU WARNING | ECU Warning | The engine ECU has detected a warning alarm and has informed the DSE module. The exact error is also indicated on the module's display. | Warning | |
| ENGINE HIGH TEMPERATURE | Engine High Temperature | The engine coolant temperature has exceeded the high engine temperature pre-alarm setting level after the Safety On timer has expired. | Warning | |
| ENGINE LOW TEMPERATURE | Engine Low Temperature | The engine coolant temperature has fallen below the high engine temperature pre-alarm setting level. | Warning | |
| FAIL TO STOP | Fail To Stop | The module has detected a condition that indicates that the engine is running when it has been instructed to stop. Could indicate a faulty oil pressure sensor or switch. | Warning | If the engine is at rest check oil sensor wiring and configuration. |
| FUEL USAGE | Fuel Usage | Indicates the amount of fuel measured by the fuel level sensor is in excess of the Fuel Usage alarm settings. Often indicates a fuel leak or potential fuel theft. | Warning | |
| GENERATOR OVER FREQUENCY | Generator Over Frequency | The generator output frequency has risen above the pre-set pre-alarm setting. | Warning | |
| GENERATOR OVER VOLTAGE | Generator Over Voltage | The generator output voltage has risen above the pre-set pre-alarm setting. | Warning | |
| GENERATOR UNDER FREQUENCY | Generator Under Frequency | The generator output frequency has fallen below the pre-set pre-alarm setting after the Safety On timer has expired. | Warning | |
| GENERATOR UNDER VOLTAGE | Generator Under Voltage | The generator output voltage has fallen below the pre-set pre-alarm setting after the Safety On timer has expired. | Warning | |
| LOADING FREQUENCY NOT REACHED | Loading Frequency Not Reached | The generator frequency is not above the configured loading frequency. The generator will not take load when the alarm is present after the safety timer. | Warning | |
| LOADING VOLTAGE NOT REACHED | Loading Voltage Not Reached | The generator voltage is not above the configured loading voltage. The generator will not take load when the alarm is present after the safety timer. | Warning | |
| LOW FUEL LEVEL | Low Fuel Level | The level detected by the fuel level sensor is below the low fuel level setting. | Warning | |
| LOW OIL PRESSURE | Low Oil Pressure | The engine oil pressure has fallen below the low oil pressure pre-alarm setting level after the Safety On timer has expired. | Warning | |
| OVERSPEED | Overspeed | The engine speed has risen above the overspeed pre alarm setting. | Warning | |
| PROTECTIONS DISABLED | Protections Disabled | Shutdown and electrical trip alarms can be disabled by user configuration; the alarm text is displayed but the engine will continue to run. Available from V4 onwards. | Warning | |
| UNDERSPEED | Underspeed | The engine speed has fallen below the underspeed pre alarm setting. | Warning | |
| kW OVERLOAD | kW Overload | The measured Total kW is above the setting of the kW overload warning alarm. | Warning |
Extracted from the manufacturer documentation linked to this model. Values are copied as printed; confirm against your unit's manual and serial number.
⚠ When replacing batteries, use the same number and battery type.
⚠ Disconnect charging source prior to connecting or disconnecting battery terminals.
⚠ A battery presents a risk of electrical shock and high short circuit current.
⚠ ECU override is only applicable if the ECU is unpowered when in STOP mode.
Extracted from the manufacturer documentation linked to this model. Values are copied as printed; confirm against your unit's manual and serial number.
The 8361 SRi 26 powers 1 generator set(s), including Himoinsa HIW-210.
The 8361 SRi 26 oil change interval is every 500 hours.