The DSE6010-MKII is a generator-set controller.
| Communications | CAN |
|---|---|
| Digital inputs | ["Digital Input A", "Digital Input B", "Digital Input C", "Digital Input D", "Digital Input E", "Digital Input F", "Analogue Input A (Set As Digital)", "Analogue Input B (Set As Digital)", "Analogue Input C (Set As Digital)", "Analogue Input D (Set As Digital)"] |
| Relay outputs | ["Digital Output A", "Digital Output B", "Digital Output C", "Digital Output D", "Digital Output E", "Digital Output F"] |
| Code | Meaning |
|---|---|
| 1 | Air Flap Relay |
| 10 | Charge Alternator Shutdown |
| 100 | Over Frequency Overshoot |
| 101 | Display Heater Fitted and Active |
| 11 | Charge Alternator Warning |
| 12 | Close Gen Output Pulse |
| 13 | Close Mains Output Pulse |
| 14 | Common Alarm |
| 15 | Common Shutdown |
| 16 | Digital Input A |
| 17 | Digital Input C |
| 18 | Digital Input E |
| 19 | Air Filter Maintenance Output |
| 2 | Flexible Sender C High Alarm |
| 20 | System In Auto Mode |
| 29 | Emergency Stop |
| 3 | Battery Over Volts Warning |
| 30 | Energise To Stop |
| 31 | Fail To Start |
| 32 | Fail To Stop |
| 33 | Fuel Relay |
| 4 | Battery Under Volts Warning |
| 5 | CAN ECU Data Fail |
| 6 | CAN ECU Error |
| 62 | Under Frequency Shutdown |
| 63 | Under Speed Shutdown |
| 64 | Flexible Sender A High Alarm |
| 65 | Flexible Sender A High Alarm |
| 66 | Flexible Sender A Low Pre-Alarm |
| 67 | Flexible Sender A Low Alarm |
| 7 | CAN ECU Fail |
| 8 | CAN ECU Power |
| 9 | CAN ECU Stop |
| 96 | System In Test Mode |
| 97 | Loss Of MPU Signal |
| 98 | MPU Open Circuit |
| 99 | Over Speed Overshoot |
| Symptom |
|---|
| Gas Choke On |
| Waiting For Manual Restore |
| Audible Alarm |
| Generator Available |
| Flexible Sender C Low Pre-Alarm |
| Flexible Sender C Low Alarm |
| Generator Over Voltage Shutdown |
| Generator Under Voltage Shutdown |
| kW Overload Alarm |
| Over Current Immediate Warning |
| High Coolant Temperature |
| Mains High Frequency |
| Mains High Voltage |
| Mains Low Frequency |
| Close Gen Output |
| Close Mains Output |
| Combined Mains Failure |
| Common Electrical Trip |
| Common Warning |
| Cooling Down |
| Digital Input B |
| Digital Input D |
| Digital Input F |
| Oil Filter Maintenance Output |
| System In Stop Mode |
| System In Manual Mode |
| Mains Transient Delay |
| Return Delay |
| Delayed Load Output 2 |
| Start Delay |
| Cooling Time |
| Delayed Load Output 3 |
| Preheat Timer |
| Crank Time |
| Smoke Limiting |
| Smoke Limiting Off |
| Safety On Delay |
| Warm Up Time |
| Crank Rest Time |
Fault codes and symptom→remedy steps extracted from this controller’s service/owner documentation; verify against the official manual before servicing. Extracted directly from this controller's manual.