HomeControllersDSE4510-MKII

DSE4510-MKII Controller

The DSE4510-MKII is a generator-set controller.

Specifications

Relay outputs["2 - Time Delay Starting Or Closing Relay", "3 - Checking Or Interlocking Relay", "5 - Stopping Device", "6 - Starting Circuit Breaker", "8 - Control Power Disconnecting Device", "10 - Unit Sequence Switch", "11 - Multifunction Device", "12 - Overspeed Device", "14 - Underspeed Device"]
Protections["IP65 (Front of module when module is installed into the control panel with the optional sealing gasket)", "IP42 (front of module when module is installed into the control panel WITHOUT being sealed to the panel)"]

Troubleshooting

23

Fault codes

CodeMeaningRemedy
057-260Module or engine ECU detected water in fuel.Contact the engine manufacturer for further details.

Symptoms & remedies

SymptomCause
Check Engine FaultThe engine ECU has detected a fault not recognised by the DSE module, contact engine manufacturer for support.
Low Oil PressureThe engine ECU has detected that the engine oil pressure has fallen below its configured low oil pressure alarm level.
Under SpeedThe engine ECU has detected that the engine speed has fallen below its configured under speed alarm level.
Over SpeedThe engine ECU has detected that the engine speed has risen above its configured over speed alarm level.
Charge FailureThe engine ECU has detected that the engine’s charge alternator output has fallen below its configured alarm level.
Low Fuel LevelThe engine ECU has detected that the engine’s fuel level has fallen below its configured low fuel level alarm.
Battery Under/Over VoltageThe engine ECU has detected that the engine’s DC supply has fallen below or risen above its configured alarm level.
Mains High Voltage
Mains Low Voltage
Mains High Frequency
Mains Low Frequency
Fuel Filter Maintenance Alarm
Water In Fuel
Fuel Usage Alarm
DPTC Filter
Fuel consumption is higher than expected.
DPF regeneration required. Contact engine manufacturer for further details.
DEF level low
SCR system fault detected. Contact engine manufacturer for further details.
Cooling fan speed too low
Fuel has leaked in the bund of the fuel tank
Coolant level alarm

Fault codes and symptom→remedy steps extracted from this controller’s service/owner documentation; verify against the official manual before servicing. Extracted directly from this controller's manual.